CLI Guide

Version Description
9.11(0.0) Introduced on the M I/O Aggregator and FN IOM.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
9.9(0.0) Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000,
S6000–ON, Z9500, MXL.
Usage
Information
This command is optional for SupportAssist service configuration.
territory
Configure the territory and set the coverage for the company site.
Syntax
territory company-territory
To remove the company territory information, use the no territory command.
Parameters
company-
territory
Enter the territory name for the company. To include a space, enter a space within
double quotes. Use three-letter country codes like USA, IND, FRA, GER and so on.
Command Modes SUPPORTASSIST COMPANY
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the M I/O Aggregator and FN IOM.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
9.9(0.0) Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000,
S6000–ON, Z9500, MXL.
Usage
Information
This command is optional for SupportAssist service configuration.
SupportAssist Person Commands
Dell EMC Networking OS supports the following SupportAssist Person mode commands.
email-address
Configure the email addresses to reach the contact person.
Syntax
email-address primary email-address [alternate email-address]
To remove an email address, use the no email-address command. To remove the primary and
the alternate email addresses, use the no email-address primary and no email-address
alternate commands respectively.
SupportAssist 1553