CLI Guide

Table Of Contents

Version Description

8.3.7.0 Introduced on the S4810.

8.5.1.0 Added support for 4-port 40G line cards on the E-Series.

8.1.1.0 Introduced on the E-Series.

7.8.1.0 Output augmented with diagnostic data for pluggable media.

7.7.1.0 Removed three fields in the output: Vendor Name, Vendor OUI, and Vendor PN.

7.6.1.0 Introduced on the C-Series and S-Series.

6.5.4.0 Introduced on the E-Series.

Usage

Information

The following describes the columns displayed in the output of the show interfaces transceiver

command:

Line Description

Rx Power

measurement

type

Output depends on the vendor, typically either “Average” or “OMA” (Receiver

optical modulation amplitude).

Tx Power

measurement

type

Output depends on the vendor, typically either “Supported” or “Not supported”.

Temp High Alarm

threshold

Factory-defined setting, typically in Centigrade. Value differs between SFPs and

SFP+.

Voltage High

Alarm threshold

Displays the interface index number used by SNMP to identify the interface.

Bias High Alarm

threshold