CLI Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
Although the passive interface does not send nor receive routing updates, the network on that interface
is still included in the IS-IS updates sent using other interfaces.
redistribute
Redistribute routes from one routing domain to another routing domain.
Syntax
redistribute {static | connected | rip} [level-1 | level-1-2 | level-2]
[metric metric-value] [metric-type {external | internal}] [route-map map-
name]
To end redistribution or disable any of the specified keywords, use the no redistribute {static |
connected | rip} [metric metric-value] [metric-type {external | internal}]
[level-1 | level-1-2 | level-2] [route-map map-name] command.
Parameters
connected Enter the keyword connected to redistribute active routes into IS-IS.
rip Enter the keyword rip to redistribute RIP routes into IS-IS.
static Enter the keyword static to redistribute user-configured routes into IS-IS.
metric metric-
value
(OPTIONAL) Assign a value to the redistributed route. The range is from 0 to
16777215. The default is 0. Use a value that is consistent with the destination
protocol.
metric-type
{external |
internal}
(OPTIONAL) The external link type associated with the default route advertised
into a routing domain. Specify one of the following:
● external
● internal
level-1 (OPTIONAL) Routes are independently redistributed into IS-IS as Level 1 routes.
level-1-2 (OPTIONAL) Routes are independently redistributed into IS-IS as Level-1-2 routes.
level-2 (OPTIONAL) Routes are independently redistributed into IS-IS as Level 2 routes.
This setting is the default.
route-map map-
name
(OPTIONAL) If you do not enter the route-map argument, all routes are
redistributed. If a map-name value is not specified, no routes are imported.
Defaults
● metric metric-value = 0
● metric-type= internal; level-2
Command Modes
● ROUTER ISIS (for IPv4)
● CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Intermediate System to Intermediate System (IS-IS) 839