CLI Guide

● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
Use this command to confirm that the neighbor adjacencies are operating correctly. If you suspect that
they are not, you can verify the specified area addresses of the routers by using the show isis
neighbors command.
The following describes the show isis neighbors command shown in the following example.
Field Description
System Id The value that identifies a system in an area.
Interface The interface, slot, and port in which the router was discovered.
State The value providing status about the adjacency state. The range is Up and Init.
Type This value displays the adjacency type (Layer 2, Layer 2 or both).
Priority IS-IS priority the neighbor advertises. The neighbor with highest priority becomes
the designated router for the interface.
Uptime Displays the interfaces uptime.
Circuit Id The neighbor’s interpretation of the designated router for the interface.
Example
The bold sections below identify that Multi-Topology IS-IS is enabled. This command displays only one IP
address per line.
DellEMC# show isis neighbors
System Id Interface State Type Priority Uptime Circuit Id
TEST Gi 7/1 Up L1L2(M) 127 09:28:01 TEST.02
!
DellEMC#show isis neighbors detail
System Id Interface State Type Priority Uptime Circuit Id
TEST Gi 7/1 Up L1L2(M) 127 09:28:04 TEST.02 Area Address(es):
49.0000.0001
IP Address(es): 25.1.1.3*
852 Intermediate System to Intermediate System (IS-IS)