Deployment Guide

CONFIG-ROUTE-MAP mode
match interface interface
The parameters are:
○ For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport information.
○ For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
○ For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
○ For a port channel interface, enter the keywords port-channel then a number.
○ For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● Match destination routes specified in a prefix list (IPv4).
CONFIG-ROUTE-MAP mode
match ip address prefix-list-name
● Match destination routes specified in a prefix list (IPv6).
CONFIG-ROUTE-MAP mode
match ipv6 address prefix-list-name
● Match next-hop routes specified in a prefix list (IPv4).
CONFIG-ROUTE-MAP mode
match ip next-hop {access-list-name | prefix-list prefix-list-name}
● Match next-hop routes specified in a prefix list (IPv6).
CONFIG-ROUTE-MAP mode
match ipv6 next-hop {access-list-name | prefix-list prefix-list-name}
● Match source routes specified in a prefix list (IPv4).
CONFIG-ROUTE-MAP mode
match ip route-source {access-list-name | prefix-list prefix-list-name}
● Match source routes specified in a prefix list (IPv6).
CONFIG-ROUTE-MAP mode
match ipv6 route-source {access-list-name | prefix-list prefix-list-name}
● Match routes with a specific value.
CONFIG-ROUTE-MAP mode
match metric metric-value
● Match BGP routes based on the ORIGIN attribute.
CONFIG-ROUTE-MAP mode
match origin {egp | igp | incomplete}
● Match routes specified as internal or external to OSPF, ISIS level-1, ISIS level-2, or locally generated.
CONFIG-ROUTE-MAP mode
match route-type {external [type-1 | type-2] | internal | level-1 | level-2 | local }
● Match routes with a specific tag.
CONFIG-ROUTE-MAP mode
match tag tag-value
To create route map instances, use these commands. There is no limit to the number of match commands per route map, but
the convention is to keep the number of match filters in a route map low. Set commands do not require a corresponding match
command.
Configuring Set Conditions
To configure a set condition, use the following commands.
● Add an AS-PATH number to the beginning of the AS-PATH.
CONFIG-ROUTE-MAP mode
set as-path prepend as-number [... as-number]
● Generate a tag to be added to redistributed routes.
102
Access Control Lists (ACLs)