Glossary

Direct, Nu 0, 00:34:42
DellEMC#
The following example shows the show ipv6 route static command.
DellEMC#show ipv6 route static
Destination Dist/Metric, Gateway, Last Change
-----------------------------------------------------
S 8888:9999:5555:6666:1111:2222::/96 [1/0]
via 2222:2222:3333:3333::1, Te 9/1, 00:03:16
S 9999:9999:9999:9999::/64 [1/0]
via 8888:9999:5555:6666:1111:2222:3333:4444, 00:03:16
Showing the Running-Configuration for an Interface
To view the configuration for any interface, use the following command.
● Show the currently running configuration for the specified interface.
EXEC mode
show running-config interface type {slot/port}
Enter the keyword interface then the type of interface and slot/port information:
○ For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport]
information.
○ For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
○ For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port
information.
DellEMC#show run int Te 2/2
!
interface TenGigabitEthernet 2/2
no ip address
ipv6 address 3:4:5:6::8/24
shutdown
DellEMC#
Clearing IPv6 Routes
To clear routes from the IPv6 routing table, use the following command.
● Clear (refresh) all or a specific route from the IPv6 routing table.
EXEC mode
clear ipv6 route {* | ipv6 address prefix-length}
○ *: all routes.
○ ipv6 address: the format is x:x:x:x::x.
○ mask: the prefix length is from 0 to 128.
NOTE:
IPv6 addresses are normally written as eight groups of four hexadecimal digits, where each group is separated
by a colon (:). Omitting zeros is accepted as described in Addressing.
Disabling ND Entry Timeout
When a peer system warmboots or performs an ISSU, the ND entries in the local system may time out resulting in traffic loss.
You can configure the system to keep the learnt neighbor discovery entries stateless so that the ND entries do not time out. To
configure the system to keep the learnt neighbor discovery entries stateless, follow these steps:
● Disable the ND timer:
INTERFACE
452
IPv6 Routing