Install Guide

To unconfigure VAP, use the no vxlan-instance 1 command.
Parameters
instance ID Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the
initial release.
Defaults Disabled
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.10(0.1P10) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S4048–ON.
9.4(0.0) Introduced on the S6000.
Usage
Information
You must disable vxlan-instance before unconfiguring VAP.
Related
Commands
feature vxlan — Enable VXLAN configuration globally on the platform.
vxlan-instance loopback
Provision VXLAN and non-VXLAN loopback ports that support routing in and out of VXLAN tunnels and enable MAC level
loopback on all these ports.
Syntax
vxlan-instance instance ID loopback [port-channel id]
Parameters
instance ID Enter the VXLAN instance ID. The platform supports only the instance ID 1.
port-channel id (Optional) Enter the keyword port-channel and the port-channel ID to provision
VXLAN and non-VXLAN loopback ports that support routing in and out of VXLAN
tunnels.
Defaults Disabled.
Command Modes PORT CHANNEL CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Updated to enable MAC level loopback.
9.13(0.0) Introduced on the S4048T-ON, S4048–ON, S6010–ON, S6000–ON, S6100–ON,
S6000, and Z9100–ON.
Usage
Information
You must configure VXLAN globally before using VXLAN-instance. Use the no shutdown command to
enable the VXLAN instance.
Example
External Loopback:
DellEMC(conf-if-po-127)#sho c
!
interface Port-channel 127
vxlan-instance 1 loopback
1702 Virtual Extensible LAN (VXLAN)