Install Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip route summary shown in the following example.
Column
Heading
Description
Route Source Identifies how the route is configured in Dell EMC Networking OS.
Active Routes Identifies the best route if a route is learned from two protocol sources.
Non-active
Routes
Identifies the back-up routes when a route is learned by two different protocols. If
the best route or active route goes down, the non-active route becomes the best
route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised, then
information on those routes is displayed.
Total 1388
active...
Displays the number of active and non-active routes and the memory usage of
those routes. If there are no routes configured in the Dell EMC Networking OS, this
line does not appear.
Example
DellEMC> show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
ospf 100 1368 2
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388 2
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
DellEMC>
Related
Commands
● show ip route — display information about the routes found in the switch.
show ip traffic
View IP, ICMP, UDP, TCP and ARP traffic statistics.
Syntax
show ip traffic [all | cp | rp1 | rp2]
NOTE: These options are supported only on the E-Series.
Parameters
all (OPTIONAL) Enter the keyword all to view statistics from all processors. If you
do not enter a keyword, you also view all statistics from all processors.
cp (OPTIONAL) Enter the keyword cp to view only statistics from the Control
Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to view only the statistics from Route
Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to view only the statistics from Route
Processor 2.
Command Modes EXEC Privilege
824 IPv4 Routing