Reference Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1371

Table Of Contents

● If an 802.1X port is authenticated and put in the RADIUS server assigned VLAN, any change to the port access VLAN

configuration does not take effect.

● The 802.1X with VLAN assignment feature is not supported on trunk ports, dynamic ports, or with dynamic-access port

assignment through a VLAN membership.

dot1x authentication (Configuration)

Enable dot1x globally; dot1x must be enabled both globally and at the interface level.

Syntax

dot1x authentication

To disable dot1x on globally, use the no dot1x authentication command.

Defaults Disabled.

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000–ON.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the C-Series and S-Series.

7.4.1.0 Introduced on the E-Series.

Commands

● dot1x authentication (Interface) — enable dot1x on an interface.

dot1x authentication (Interface)

Enable dot1x on an interface; dot1x must be enabled both globally and at the interface level.