Reference Guide

snmp context
Configure SNMPv3 context name to map multiple OSPFv3 VRF instances.
Syntax
snmp context {context-name}
To clear snmp context, use the no snmp context {context-name} command.
Parameters
context-name Enter the SNMP context name. The maximum length is 32 alphanumeric
characters.
Defaults None.
Command Modes IPv6 ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the S3100 series, S3048–ON, S4048–ON, S4048T-ON, S5048F-ON,
S6000, S6010–ON, S6100–ON, Z9100–ON, Z9500, S6000–ON, C9010, MXL, and
FN IOM.
Usage
Information
Use SNMPv3 context configuration to distinguish between various OSPFv3 VRF instances.
Example
DellEMC(conf-ipv6-router_ospf)#snmp context ospf1
DellEMC>show runnig-config ospf
!
ipv6 router ospf 10
router-id 10.10.10.1
snmp context ospf1
!
DellEMC>
snmp ifmib ifalias long
Display the entire description string through the Interface MIB, which would be truncated otherwise to 63 characters.
Syntax
snmp ifmib ifalias long
Defaults Interface description truncated beyond 63 characters.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
1448 Simple Network Management Protocol (SNMP) and Syslog