Reference Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

151

152

153

154

155

156

157

158

159

160

Table Of Contents

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000–ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

8.4.1.0 Added the multi-auth option on the C-Series and S-Series.

8.3.2.0 Added the single-host and multi-host options on the C-Series, E-Series,

and S-Series.

Usage

Information

● Single-host mode authenticates only one host per authenticator port and drops all other traffic on the

port.

● Multi-host mode authenticates the first host to respond to an Identity Request and then permits all

other traffic on the port.

● Multi-supplicant mode authenticates every device attempting to connect to the network on the

authenticator port.

Commands

● show dot1x interface — display the 802.1X configuration of an interface.

dot1x mac-auth-bypass

Enable MAC authentication bypass. If 802.1X times out because the host did not respond to the Identity Request frame, Dell

EMC Networking OS attempts to authenticate the host based on its MAC address.

Syntax

dot1x mac-auth-bypass

To disable MAC authentication bypass on a port, use the no dot1x mac-auth-bypass command.

Defaults Disabled

Command Modes INTERFACE