Reference Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1681

Table Of Contents

priority-cost

(OPTIONAL) Enter a number as the amount to subtract from the priority value. The

range is from 1 to 254. The default is 10.

Defaults priority cost = 10

Command Modes VRRP

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

7.6.1.0 Introduced on the S-Series (S50 only).

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Usage

Information

If you disable the interface, the cost value is subtracted from the priority value and forces a new MASTER

election if the priority value is lower than the priority value in the BACKUP virtual routers.

virtual-address

Configure up to 12 virtual router IP addresses in the VRRP group. To start sending VRRP packets, set at least one virtual IP

address for the VRRP group.

Syntax

virtual-address ip-address1 [... ip-address12]

To delete one or more virtual IP addresses, use the no virtual-address ip-address1 [...

ip-address12] command.

Parameters

ip-address1

Enter an IP address of the virtual router in dotted decimal format. The IP address

must be on the same subnet as the interface’s primary IP address.

... ip-address12

(OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in dotted

decimal format. Separate the IP addresses with a space. The IP addresses must be

on the same subnet as the interface’s primary IP address.

Defaults Not configured.