Reference Guide

Version Description
7.7.1.0 Introduced on the C-Series.
Usage
Information
Although Dell EMC Networking OS does not generate a route due to the backdoor config, there is an
option for injecting/sourcing a local route in the presence of network backdoor config on a learned route.
permit bandwidth
Enables you to specify link band width extended-community attribute as the matching criteria to permit incoming or outgoing
traffic.
Syntax
permit bandwidth
To disable this setting, enter the no permit bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to specify extended-community attribute as the
matching criteria for permitting traffic. The range is from 0 to 102400.
Defaults N/A
Command Modes EXTENDED COMMUNITY LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series.
Related
Commands
● deny bandwidth – link band width extended-community attribute as the matching criteria to deny
incoming or outgoing traffic.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static} command.
Parameters
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static
Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
Border Gateway Protocol 393