Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
debug ip igmp
Enable debugging of IGMP packets.
Syntax
debug ip igmp [vrf vrf-name] [group address | interface]
● To disable IGMP debugging, use the no debug ip igmp [vrf vrf-name] [group address
| interface] command.
● To disable all debugging, use the undebug all command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable
debugging of IGMP packets corresponding to that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format.
interface
interface
Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
Defaults Disabled.
Command Modes EXEC Privilege
612 Internet Group Management Protocol (IGMP)