Reference Guide

NOTE: You cannot apply dampening on an interface that is monitoring traffic for other interfaces.
Example
DellEMC(conf-if-te-1/10/1)# dampening 20 800 4500 120
DellEMC(conf-if-te-1/10/1)#
Related
Commands
● clear dampening — clear the dampening counters on all the interfaces or just the specified interface.
● show interfaces dampening — display interface dampening information.
default interface
Reset a physical interface to its factory default settings.
Syntax
default interface interface-type slot/port[/subport] - range
Parameters
interface-type
slot/port [ /
subport ]
Enter the interface type and slot/port [/subport] information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
range
● For non-ON platforms, you can specify multiple ports as slot/port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces interface-
type 1/1 - 4.
● For ON platforms, you can specify multiple ports as slot/port/[subport]
- slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1/1 - 1/1/4.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S3100 series.
9.9(0.0) Introduced on the S4810, S4820T, S3048-ON, S4048-ON, S5000, S6000, S6000–
ON, and Z9500.
Usage
Information
Use the default interface command to set a Gigabit Ethernet, 10- Gigabit Ethernet, or 40-Gigabit
Ethernet interface to its factory-default state. By default, a physical interface is disabled (shutdown) with
no assigned IP address or switchport (no ip address). This command removes all software settings and all
L3, VLAN, VXLAN, and port-channel configurations on a physical interface.
Example
DellEMC(conf-if-te-1/5/1)# show config
!
interface TenGigabitEthernet 1/5/1
description testconfig
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
DellEMC(conf-if-te-1/5/1)#
638 Interfaces