Reference Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

891

892

893

894

895

896

897

898

899

900

Table Of Contents

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Introduced on the S-Series.

7.6.1.0 Introduced on the C-Series.

7.4.1.0 Introduced on the E-Series.

Commands

● protocol lldp (Configuration) — enable LLDP globally.

● debug lldp interface — debug LLDP.

● show lldp neighbors — display the LLDP neighbors.

hello

Configure the rate at which the LLDP control packets are sent to its peer.

Syntax

hello seconds

To revert to the default, use the no hello seconds command.

Parameters

seconds

Enter the rate, in seconds, at which the control packets are sent to its peer. The

rate is from 5 to 180 seconds. The default is 30 seconds.

Defaults 30 seconds

Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)