Users Guide

Version Description
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000,
S6000, S6000–ON, S6100–ON, the Configuration Terminal Batch mode on C9010,
Z9100–ON, and Z9500.
9.9(0.0) Introduced on the C9010.
Usage
Information
The mac command configures a list of supplicant MAC addresses for a dot1x profile represented with a
profile-name. You can configure up to 6 MAC addresses in a single mac command. The maximum number
of MAC addresses that you can configure in a single profile is limited to 100.
Use this command in Configuration Terminal Batch mode to configure a list of supplicant MAC addresses
for dot1x profile in a dual-homing setup.
Example
DellEMC(conf)#dot1x profile mySupplicants
DellEMC(conf-dot1x-profile)#mac 00:50:56:AA:01:10 00:50:56:AA:01:11
DellEMC(conf-dot1x-profile)#show config
dot1x profile mySupplicants
mac 00:50:56:aa:01:10
mac 00:50:56:aa:01:11
DellEMC(conf-dot1x-profile)#
DellEMC(conf-dot1x-profile)#exit
dot1x mac-auth-bypass
Enable MAC authentication bypass. If 802.1X times out because the host did not respond to the Identity Request frame, Dell
EMC Networking OS attempts to authenticate the host based on its MAC address.
Syntax
dot1x mac-auth-bypass
To disable MAC authentication bypass on a port, use the no dot1x mac-auth-bypass command.
Defaults Disabled
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
160 802.1X