Users Guide

Supported Modes
Command
History
Version Description
9.14.1.0 Introduced on the S4810 and S4820T.
9.13.0.0 Introduced on the MXL, FN IOM, S5000, S4048-ON, S6000, S6000-ON, S3048-
ON, S3100 Series, C9010, S4048T-ON, Z9500, Z9100-ON, S6100-ON, S6010-ON.
Usage
Information
The no cam-threshold command will set the CAM threshold to 90 percent and silence period to 0.
The CAM threshold and silence period configuration is applicable only for Ingress L2, IPv4, IPv6 and
Egress L2, IPv4, and IPv6 ACL CAM groups. For other ACL CAM regions, the CAM threshold and silence
period is not configurable and the values are fixed to 90 percent and 0 respectively.
Example
DellEMC(conf)#cam-threshold threshold 2 silence-period 2
DellEMC(conf)#do show running-config | g cam-threshold
cam-threshold threshold 2 silence-period 2
show cam-acl
Display the details of the CAM profiles on the chassis and all stack units.
Syntax
show cam-acl
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Updated to display IPv6 flow-based mirroring information on S5048F-ON, S6100–
ON, Z9100–ON, S6000, and S6000–ON. Updated to display the IPv6 ACL region in
multiples of 2 when the feature ipv6acloptimized command is enabled on
the S5048F–ON, S6100–ON, and Z9100–ON.
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series.
Usage
Information
The display reflects the settings implemented with the cam-acl command.
450 Content Addressable Memory (CAM)