Users Guide

26 | Setting Up the Monitor
Setting Up the Monitor
Attaching the stand
NOTE: The stand is not installed at the factory when shipped.
NOTE: The following instructions are applicable only for attaching the stand that was
shipped with your monitor. If you are attaching a stand that you purchased from any
other source, follow the set up instructions that were included with the stand.
To attach the monitor stand:
1 Follow the instructions on the flaps of the carton to remove the stand from the top
cushion that secures it.
2 Insert the stand base blocks fully into the stand slot.
3 Lift the screw handle and turn the screw clockwise.
4 After fully tightening the screw, fold the screw handle flat within the recess.
5 Lift the cover, as shown, to expose the VESA area for stand assembly.