Users Guide
Table Of Contents
- Safety instructions
- About your monitor
- Setting up the monitor
- Operating your monitor
- Troubleshooting
- Appendix
Operating your monitor │ 59
When the monitor goes into power-save mode, the following message appears:
Going into Standby mode...
Activate the computer and wake up the monitor to gain access to the OSD.
NOTE: The message may be slightly dierent according to the con-
nected input signal.
If either VGA, HDMI, or DisplayPort cable is not connected, a floating dialog box as
shown below appears. The monitor will enter Standby Mode after 4 minutes if left
at this state.
No VGA Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/P2X22H
or
No HDMI Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/P2X22H
or
No DP Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/P2X22H
NOTE: The message may be slightly dierent according to the con-
nected input signal.