Users Guide
Table Of Contents
- About your monitor
- Setting up the monitor
- Operating your monitor
- Power on the monitor
- Using the front panel controls
- Using the on-screen display (OSD) menu
- Setting up your monitor
- Using the Tilt, Swivel, and Vertical Extension
- Operating the webcam cover shutter
- Installing the monitor IR Camera driver
- Setting up Windows Hello
- Setting up the monitor webcam as default setting
- Setting up the monitor speaker as default setting
- Troubleshooting
- Appendix
Operating your monitor | 49
If you press any button other than the power button, the following messages will
appear depending on the selected input:
Dell
P2418HZm
No VGA signal from your device.
?
Press any key on the keyboard or move the mouse to wake it up.
the correct input source.
If there is no display, press the monitor button again to select
If VGA, HDMI, or DP cable is not connected, a floating dialog box as shown below
appears. The monitor will enter Power Save Mode after 4 minutes if left at this state.
Dell
P2418HZm
No VGA Cable
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
?
or
Dell
P2418HZm
No HDMI Cable
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
?
or
Dell
P2418HZm
No DP Cable
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
?
See Troubleshooting for more information.