Users Guide
Table Of Contents
- About your monitor
- Setting up the monitor
- Operating your monitor
- Power on the monitor
- Using the front panel controls
- Using the on-screen display (OSD) menu
- Setting up your monitor
- Using the Tilt, Swivel, and Vertical Extension
- Operating the webcam cover shutter
- Installing the monitor IR Camera driver
- Setting up Windows Hello
- Setting up the monitor webcam as default setting
- Setting up the monitor speaker as default setting
- Troubleshooting
- Appendix
26 | Setting up the monitor
Setting up the monitor
Attaching the stand
NOTE: The stand is detached when the monitor is shipped from the factory.
NOTE: This is applicable for a monitor with a stand. When any other stand
is bought, please refer to the respective stand setup guide for the set up
instructions.
To attach the monitor stand.
1.
Follow the instructions on the flaps of carton to remove the stand from the top
cushion that secures it.
2.
Insert the stand base blocks fully into the stand slot.
3.
Lift the screw handle and turn the screw clockwise.
4.
After fully tightening the screw, fold the screw handle flat within the recess.
5.
Lift the cover, as shown, to expose the VESA area for stand assembly.