Users Guide
Table Of Contents
- About your monitor
- Setting up the monitor
- Operating your monitor
- Power on the monitor
- Using the front panel controls
- Using the on-screen display (OSD) menu
- Setting up your monitor
- Using the Tilt, Swivel, and Vertical Extension
- Operating the webcam cover shutter
- Installing the monitor IR Camera driver
- Setting up Windows Hello
- Setting up the monitor webcam as default setting
- Setting up the monitor speaker as default setting
- Troubleshooting
- Appendix
28 | Setting up the monitor
Connecting your monitor
WARNING: Before you perform any of the procedures in this section, follow
the Safety instructions.
NOTE: Do not connect all cables to the computer at the same time. It is
recommend to route the cables through the cable-management slot before you
connect them to the monitor.
To connect your monitor to the computer:
1.
Turn off your computer and disconnect the power cable.
2.
Connect the VGA, HDMI or DP cable from your monitor to the computer.
Connecting the VGA cable
Connecting the HDMI cable (optional)