User's Manual
The BIOS Configuration Utility prompt times out after several seconds.
The host controller number, firmware version, and cache SDRAM size display in the second portion of the BIOS message. The numbering of the controllers
follows the PCI slot scanning order used by the host motherboard.
Light-emitting Diode (LED) Description
When you start the system, the boot block and firmware perform a number of steps that load the operating system and allow the system to function properly.
The boot block contains the operating system loader and other basic information needed during startup.
As the system boots, the LEDs indicate the status of the boot block and firmware initialization and whether the system performed the steps correctly. If there
is an error during startup, you can use the LED display to identify it.
Table3-4 displays the LEDs and execution states for the boot block. Table3-5 displays the LEDs and execution states during firmware initialization. The LEDs
display in hexadecimal format so that you can determine the number and the corresponding execution state from the LEDs that display.
Table 3-4.BootBlockStates
Table 3-5.FirmwareInitializationStates
Step 9 Run the BIOS Configuration Utility or Dell Manager
Press <Ctrl><M> when prompted during the boot process to run the BIOS Configuration Utility. You can run Dell Manager in Red Hat Linux to perform the same
functions, such as configuring arrays and logical drives.
See BIOS Configuration Utility and Dell Manager for additional information about running the BIOS Configuration Utility and Dell Manager.
Step 10 Install an Operating System
Install one of the following operating systems: Microsoft®Windows NT®, Windows®2000, Windows 2003, Novell®NetWare®, and Red Hat Linux.
LED
Execution State
0x01
Setup 8-bit Bus for access to Flash and 8 Bit devices successful
0x03
Serial port initialization successful
0x04
Spd (cache memory) read successful
0x05
SDRAM refresh initialization sequence successful
0x07
Start ECC initialization and memory scrub
0x08
End ECC initialization and memory scrub
0x10
SDRAM is present and properly configured. About to program ATU.
0x11
CRC check on the firmware image successful. Continue to load firmware.
0x12
Initialization of SCSI chips successful.
0x13
BIOS protocols ports initialized. About to load firmware.
0x17
Firmware is either corrupt or BIOS disabled. Firmware was not loaded.
0x19
Error ATU ID programmed.
0x55
System Halt: Battery Backup Failure
LED
Execution State
0x1
Begin Hardware Initialization
0x3
Begin Initialize ATU
0x7
Begin Initialize Debug Console
0xF
Set if Serial Loopback Test is successful