User's Manual
Table Of Contents
- Contents
- CAUTION: Safety Instructions
- When Using Your Computer
- A Tour of Your Computer
- Setting Up Your Computer
- Using a Battery
- Using the Keyboard and Touch Pad
- Using CDs, DVDs, and Other Multimedia
- Setting Up a Home and Office Network
- Solving Problems
- Finding Solutions
- Accessing Help
- Error Messages
- Video and Display Problems
- Scanner Problems
- Drive Problems
- PC Card Problems
- General Program Problems
- Resolving Other Technical Problems
- If Your Computer Gets Wet
- If You Drop or Damage Your Computer
- Drivers
- Resolving Software and Hardware Incompatibilities
- Using System Restore
- Reinstalling Microsoft® Windows® XP
- Adding and Replacing Parts
- Appendix
- Index
Adding and Replacing Parts 109
3 Remove the screw labeled "O" next to the memory module cover.
4 Press the lever next to the memory module connectors in the direction of the arrow on
the lever (towards the drive) to release the drive.
5 Pull the drive out of the bay.
6 Slide the new drive into the bay until the drive is fully seated.
7 Replace the screw that you removed in step 3.
8 Replace the memory module cover and screw.
Keyboard
1 Complete the instructions in "Before You Add or Replace Parts" on page 100.
2 Use a small flat-blade screwdriver or plastic scribe to lift the notched right edge of the
hinge cover, and pry the cover loose from the hinges and bottom case.
screw
lever
CD or DVD
drive