Manualshelf

User's Manual

ManualsBrandsDell ManualsPersonal ComputerDell Personal Computer 690
111112113114115116117118119120
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
11. Ensure that memory riser card 3 is above system-board connector DIMM_3 and memory riser card 4 is above system-board connector DIMM_4.
Align the notch on the bottom of each riser card with the crossbar in each system-board connector.
12. Insert the riser cards into the connectors until both riser cards snap into position.
13. Connect the power cables back into memory riser cards 3 and 4.
14. Ensure that memory riser card 1 is above system-board connector DIMM_1 and memory riser card 2 is above system-board connector DIMM_2.
Align the notch on the bottom of each riser card with the crossbar in each system-board connector.
15. Insert the riser cards into the connectors until both riser cards snap into position.
16. Connect the power cables back into memory riser cards 1 and 2.
1
memory riser cards 1 and 2
2
memory riser cards 3 and 4
NOTE: If a memory-riser power cable is not plugged in, the system will not boot.
NOTE: If a memory-riser power cable is not plugged in, the system will not boot.
1
memory shroud