User's Manual


10. Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot
If there is a release tab on the card slot, pull the release tab.

11. Before you rotate the card retainer back into place, ensure that:
l The tops of all cards and filler brackets are flush with the alignment bar.
l The notch in the top of each card or filler bracket fits around the alignment guide.

12. Rotate the card retainer until it snaps into place.
1
bracket within slot
2
bracket caught outside of slot
3
card fully seated
4
card not fully seated
NOTE: For extra security, remove the alignment guide (an upside-down screw) and screw it in right side up to secure a card.
1
card retainer
2
alignment bar
3
alignment guide

NOTE: For extra security, remove the alignment guide (an upside-down screw) and screw it in right side up to secure a card.
4
filler bracket
NOTICE: Do not route card cables behind the cards. Cables routed behind the cards could cause damage to the equipment.