Specifications

1. From the Privileged Exec level global configuration mode prompt, type interface vlan 1 to access the interface-configuration mode. Press <Enter>.
2. At the next prompt, use one of the following commands:
l To obtain IP settings through DHCP, type ip address dhcp
l To obtain IP setting through BOOTP, type ip address bootp
3. Press <Enter>.
4. To save your configuration changes, type copy running-config startup-config, and then press <Enter>.
Connecting Devices to the Switch
After you assign IP addresses to the switch, you can connect devices to the RJ-45 connectors on the switch.

To connect a device to an SFP transceiver port:
1. Use your cabling requirements to select an appropriate SFP transceiver type.
2. Insert the SFP transceiver (sold separately) into the SFP transceiver slot.
3. Use the appropriate network cabling to connect a device to the connectors on the SFP transceiver. The slot's LED indicator turns on to confirm that it is
correctly installed and operating.

Back to Contents Page

NOTICE: If autonegotiation is disabled for an RJ-45 port, the auto-MDI/MDI-X pin signal configuration is also disabled.
NOTICE: When the SFP transceiver acquires a link, the associated integrated 10/100/1000BASE-T port is disabled.