Specifications

Example

Console(config)#interface ethernet 1/5

Console(config-if)#

Console(config-if)#description RD SW#3

Console(config-if)#no negotiation

Console(config-if)#speed-duplex 100half

Console(config-if)#flowcontrol
Trunk Configuration
On the Trunk Configuration page, you can enable and disable the aggregate port links that have been created on the switch. To set up trunks and select
port members, use the Link Aggregation page.
For each trunk number listed in the Trunk column, you can change the following parameters listed by column name on the screen:
l Name/Type — Allows a user-defined label for the trunk and also indicates the type of ports in the trunk
l Admin/Oper — Allows the network administrator to manually disable a trunk and also indicates the status of the link: up or down
l Speed/Duplex Mode — Allows the manual selection of port speed and duplex mode and also indicates the current speed and mode of member ports
l Flow Control — Allows automatic or manual selection of support for flow control and also indicates the type of flow control currently in use
l Autonegotiation/Port Capabilities — Allows autonegotiation to be enabled/disabled for all ports in the trunk and also indicates the capabilities of the
port members
To save any changes you make in this page, click Apply Changes. If you don't want to save the changes, click Refresh.

without parameters command to restore the default values.
flowcontrol
Enables flow control.
Use the no form command to disable flow control.
show interfaces status ethernet unit/port
Displays status for enabled interfaces.
show interfaces switchport [ethernet unit/port]
Displays the configuration for a port.