Specifications

l Mode – Indicates the VLAN membership mode for a port.
(Default: Hybrid)
¡ 1Q Trunk — Specifies a port as an end point for a VLAN trunk. A trunk is a direct link between two switches, so the port transmits tagged frames
that identify the source VLAN.
¡ Hybrid — Specifies a hybrid VLAN interface. The port may transmit tagged or untagged frames.

To save any changes you make in this page, click Apply Changes. If you don't want to save the changes, click Refresh.

CLI Commands
The following table summarizes the equivalent CLI commands for items in the VLAN/Port Settings page.

Example

Console(config)#interface ethernet 1/1

Console(config-if)#switchport native vlan 3

NOTICE: If Mode is set to 1Q Trunk, frames belonging to the port's default VLAN (i.e., associated with the PVID) are sent untagged, but all other frames
are tagged with the assigned VLAN ID.
Command
Usage
switchport native vlan vlan-id
Configures the PVID (default VLAN ID) for a port
switchport acceptable-frame-types {all | tagged}
Configures the acceptable frame types for a port
switchport ingress-filtering
Enables ingress filtering for a port
switchport gvrp
Enables GVRP for a port
garp timer {join | leave | leaveall} timer_value
Sets the values for the GVRP join, leave, and leaveall timers
show gvrp configuration [interface]
Shows whether GVRP is enabled