Users Guide

Dell PowerConnect 55xx Systems User Guide 161
The following is an example of the CLI commands:
power inline priority
{critical|high|low}
no power inline priority
Configures the priority of the interface
from the point of view of inline power
management.
Use the no form of this command to
restore the default configuration.
power inline usage-threshold
no power inline usage-
threshold
Configures the threshold for triggering
alarms.
Use the no form of this command to
restore the default configuration.
power inline traps enable
no power inline traps enable
Enables PoE device traps.
Use the no form of this command to
disable traps.
power inline limit-mode
{class|port}
no power inline limit-mode
Sets the power limit mode of the system.
Use the no form of this command to
return to default.
show power inline
[[[gigabitethernet|tengigabi
tethernet]port-number|vlan
vlan-id|port-channel LAG-
number]|module stack-member-
number]
Displays PoE configuration information
for all interfaces or for a unit in the stack.
console# show power inline
Unit Power Nominal Power Consumed Power Usage Threshold Traps
---- ------- ------------- ------------------ --------------- -----
1 Off 1 Watts 0 Watts (0%) 95 Disable
2 Off 1 Watts 0 Watts (0%) 95 Disable
3 Off 1 Watts 0 Watts (0%) 95 Disable
4 Off 1 Watts 0 Watts (0%) 95 Disable
Table 9-4. Power Over Ethernet CLI Commands (Continued)
CLI Command Description