Users Guide

Dell PowerConnect 55xx Systems User Guide 217
Defining IPv6 Interfaces Using CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the IPv6 Interface pages.
Table 9-26. IPv6 Interfaces CLI Commands
CLI Command Description
ipv6 enable [no-autoconfig]
no ipv6 enable
Enables the IPv6 addressing mode on an
interface.
Use the no form of this command to
disable the IPv6 addressing mode on an
interface
ipv6 address autoconfig
no ipv6 address autoconfig
Enables automatic configuration of IPv6
addresses, using stateless auto
configuration on an interface. Addresses
are configured depending on the prefixes
received in Router Advertisement
messages.
Use the no form of this command to
disable address auto configuration on the
interface.
ipv6 icmp error-interval
milliseconds [bucketsize]
no ipv6 icmp error-interval
Configures the rate limit interval and
bucket size parameters for IPv6 Internet
Control Message Protocol (ICMP) error
messages.
Use the no form of this command to
return the interval to its default setting.
ipv6 address ipv6-
address/prefix-length [eui-64]
[anycast]
no ipv6 address [ipv6-
address/prefix-length] [eui-
64]
Configures an IPv6 address for an
interface.
Use the no form of this command to
remove the address from the interface.