Users Guide

Dell PowerConnect 55xx Systems User Guide 257
– Rule Priority (1-65535) — Enter the rule priority. Rules are applied to
packets according to their priority. These can be viewed in the
Profile
Rules: Summary
page.
–
Management Method — Select the management method to which
the access profile is applied. Users using this management method are
authenticated using this access profile. The possible options are:
•
All — The access profile is applied to all management methods.
•
Telnet — The access profile is applied to Telnet users.
•
Secure Telnet (SSH) — The access profile is applied to SSH
users.
•
HTTP — The access profile is applied to HTTP users.
•
Secure HTTP (HTTPS) — The access profile is applied to
HTTPS users.
•
SNMP — The access profile is applied to SNMP users.
–
Interface — Check the fields and select the interface type to which
the rule applies.
–
Enable Source IP Address — Check this parameter to restrict access,
based on the source IP address. When this field is not selected, the
source IP address cannot be entered into a configured rule.
–
Supported IP Format — Select whether the IPv4 or IPv6 format is
supported for the source IP addresses.
–
Source IP Address — Enter the interface source IP address for which
the rule applies. This is an optional field and indicates that the rule is
valid for a subnetwork.
–
Network Mask — Enter the IP subnetwork mask if Supported IP
Format
is IPv4.
–
Prefix Length — Enter the number of bits that comprise the source IP
address prefix, or the network mask of the source IP address.
–
Action — Select whether to permit or deny management access to the
defined interface. The possible options are:
•
Permit — Permits access to the device.
•
Deny — Denies access to the device.