Users Guide

414 Dell PowerConnect 55xx Systems User Guide
Configuring Port Mirroring Using CLI Commands
The following table summarizes the CLI commands for configuring Port
Mirroring.
The following is an example of the CLI commands:
Table 10-11. Port Mirroring CLI Commands
CLI Command Description
port monitor src-
interface-id [rx|tx]
no port monitor src-
interface-id
Starts a port monitoring session. This must
be performed in Interface Configuration
mode, which is the destination interface.
Use the no form of this command to stop a
port monitoring session.
show ports monitor Displays the port monitoring status.
console(config)# interface gi1/0/1
console(config-if)# port monitor gi1/0/8
console# show ports monitor
Source port Destination Port Type Status
----------- ---------------- ---- -----------
gi1/0/1 gi1/0/8 RX,TX Active