Users Guide

Dell PowerConnect 55xx Systems User Guide 515
Managing Bridge Multicast Groups Using CLI Commands
The following table summarizes the CLI commands for managing Multicast
service members as displayed in the Bridge Multicast Group pages.
The following is an example of the CLI commands:
Table 16-3. Bridge Multicast Group CLI Commands
CLI Command Description
bridge multicast address {mac-
multicast-address|ip-multicast-
address}
no bridge multicast filtering
Registers MAC-layer Multicast
addresses to the bridge table, and
adds static ports to the group.
Use the no form of this command to
disable Multicast address filtering.
bridge multicast forbidden
address
{mac-multicast-
address|ip-multicast-
address}[add|remove]
{[gigabitethernet|tengigabitethe
rnet] interface-list|port-
channel
LAG-number-list}
no bridge multicast forbidden
address {mac-multicast-address}
Forbids adding a specific Multicast
address to specific ports. Use the no
form of this command to return to
default
Use the no form of this command to
restore the default configuration.
show bridge multicast address-
table [vlan
vlan-id] [address
{mac-multicast-address|ip-
multicast-address}
] [format
ip|mac]
Displays Multicast MAC address
table information.
console(config-if)# bridge multicast address 0100.5e02.0203
add gi1/0/11,gi1/0/12
console(config-if)# end
console # show bridge multicast address-table
VLAN MAC Address Type Ports
---- ----------- ----- ----------
1 0100.5e02.0203 static gi1/0/11,
gigi1/0/12
Forbidden ports for multicast addresses: