Users Guide

518 Dell PowerConnect 55xx Systems User Guide
– Static — Displays available static ports/LAGs. These port/LAGs can
be included or excluded from the Multicast groups, as described
below.
–
Current — Displays status of ports/LAGs, as actually applied, in the
Multicast group.
Managing LAGs and Ports Attached to Multicast Routers Using CLI Commands
The following table summarizes the CLI commands for managing LAGs and
ports attached to Multicast routers as displayed on the Bridge Multicast
Forward All page.
The following is an example of the CLI commands:
Table 16-4. Managing LAGs and Ports Attached to Multicast Routers CLI Commands
CLI Command Description
show bridge multicast filtering
vlan-id
Displays the Multicast filtering
configuration.
bridge multicast forward-all
{
add|remove}
{
[gigabitethernet|tengigabitethe
rnet]
interface-list|port-
channel LAG-number-list}
Enables forwarding of all Multicast
packets on a port.
Use the no form of this command to
return to default.
console(config)# interface vlan 1
console(config-if)# bridge multicast forward-all add
gi1/0/3
console(config-if)# end
console# show bridge multicast filtering 1
Filtering: Enabled
VLAN: Forward-All
Port Static Status
------- ----------------- -----------
gi1/0/11 Forbidden Filter
gi1/0/12 Forward Forward(s)
gi1/0/13 - Forward(d)