Owner's Manual

192 IP Routing Protocol-Independent Commands
www.dell.com | support.dell.com
Examples
The following example displays the whole routing table state.
The following example displays the routing table for IP address 192.168.1.0 with the address mask
255.255.255.0.
Console> show ip route
Maximum Parallel Paths: 2 (4 after reset)
Codes: C - connected, S - static, R - RIP, O - OSPF, E - OSPF
external
R 10.0.0.0/8 is rejected
C 10.0.1.1/32 is directly connected, Loopback0
C 10.0.1.0/24 is directly connected, Ethernet g1
C 10.0.2.0/24 is directly connected, Ethernet g2
R 10.8.2.0/24 [230/50] via 10.0.2.2, 00:17:19, Ethernet g2
S 10.9.1.0/24 [5/2] via 10.0.1.2, 17:19:18, Ethernet g1
S 10.9.1.0/24 [5/3] via 10.0.2.2, Backup Not Active
O 10.8.1.0/24 [30/2000] via 10.0.1.2, 00:39:08, Ethernet g1
S 172.1.0.0/16 [5/3] via 10.0.1.1, 18:21:58, Ethernet g1
S 172.1.1.0/24 [5/3] via 10.0.2.1, 17:12:19, Ethernet g1
S 172.1.1.1/32 [5/3] via 10.0.3.1, 19:51:18, Ethernet g1
Console> show ip route address 192.168.1.0 255.255.255.0
Codes: C - connected, S - static, R - RIP, O - OSPF,
E - OSPF external
S 192.168.1.0/24 [5/3] via 10.0.2.1, 17:12:19, Ethernet g1