Owner's Manual

254 OSPF Commands
www.dell.com | support.dell.com
Example
The following example displays parameters and the current state of OSPF virtual links.
The following table describes the fields the display:
show ip ospf database
The show ip ospf database user EXEC command displays information lists related to the OSPF
database. The various forms of this command deliver information about different OSPF link-state
advertisements (LSAs).
Syntax
show ip ospf [ area-id ] database
show ip ospf
[ area-id ] database [ adv-router [ ip-address ]]
show ip ospf [ area-id ] database [ asbr-summary ] [ link-state-id ]
show ip ospf [ area-id ] database [ asbr-summary ] [ link-state-id ] [ adv-router
[ ip-address ]]
Console# show ip ospf virtual-links
Virtual Link to router 192.168.101.2 is up
Transit area 0.0.0.1
Virtual link has simple password authentication
Transmit Delay is 1 sec, State POINT_TO_POINT
Timer intervals configured, Hello 10, Dead 40, Retransmit 5
Adjacency State FULL
Field Description
Virtual Link to router
192.168.101.2 is up
Specifies the OSPF neighbor, and if the link to that neighbor is up or
down.
Transit area 0.0.0.1 The transit area through which the virtual link is formed.
Transmit Delay is 1 sec The transmit delay (in seconds) on the virtual link.
State POINT_TO_POINT The state of the OSPF neighbor.
Timer intervals... The various timer intervals configured for the link.
Adjacency State FULL The adjacency state between the neighbors.