Owner's Manual

30 Command Groups
www.dell.com | support.dell.com
Configuration and Image Files Commands
DHCP Relay Commands
Ethernet Configuration Commands
show sntp configuration Displays the SNTP configuration PE
show sntp status Displays the SNTP status PE
Command Group Description Mode
configure Enters the global configuration mode. PE
copy Copies files from a source to a destination. PE
delete startup-config Deletes the startup-config file. PE
boot system Specifies the system image that the device loads at startup. PE
show running-config Displays the contents of the currently running configuration file. PE
show startup-config Displays the startup configuration file contents. PE
show backup-config Displays the backup configuration file contents. PE
show bootvar Displays the active system image file that the device loads at startup. PE
Command Group Description Mode
ip dhcp relay enable Enables DHCP relay features on the router. GC
ip dhcp relay address Defines the DHCP address available for the DHCP relay. GC
show ip dhcp relay Displays the DHCP relay server addresses. PE
Command Group Description Mode
interface ethernet Enters the interface configuration mode to configure an Ethernet type
interface.
GC
interface range ethernet Enters the interface configuration mode to configure multiple
Ethernet type interfaces.
GC
interface out-of-band-eth Configures the out-of-band Ethernet port and enter interface
configuration mode.
IC
shutdown Disables interfaces. IC
description Adds a description to an interface. IC