Owner's Manual

QoS Commands 309
The service-policy interface configuration command cannot be used to attach policy maps
that contain
set or trust policy-map class configuration commands or that have access control
list (ACL) classification to an egress interface. The only match criterion supported is
match
ip dscp
dscp-lis t. For non-IP packets, the final CoS is converted to DSCP for classification
purposes. If there is an attempt to apply a policy map on an egress interface with anything
other than the
match ip dscp class-map configuration command, an error message is
generated.
Example
The following example creates policy map called "policy1".
show policy-map
The show policy-map user EXEC command displays the defined policy maps.
Syntax
show policy-map [ policy-map-name [ class class-name ]]
•
policy-map-name —The policy map name being displayed.
•
class class-name —Displays the QoS policy action for individual classes.
Default Configuration
If a specific policy-map is not requested, all policy-maps are displayed.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Console (config)# policy-map policy1
Console (config-pmap)#