Owner's Manual

Command Groups 31
GVRP Commands
speed Configures the speed of a given Ethernet interface when not using
auto-negotiation.
IC
duplex Configures the full/half duplex operation of a given Ethernet interface
when not using auto-negotiation.
IC
negotiation Enables auto-negotiation operation for the speed and duplex
parameters of a given interface.
IC
flowcontrol Configures the Flow Control on a given interface. IC
mdix Enables automatic crossover on a given interface. IC
back-pressure Enables Back Pressure on a given interface. IC
port jumbo-frame Enables jumbo frames for the device. GC
clear counters Clears statistics on an interface. UE
set interface active Reactivates an interface that was suspended by the system. PE
show interfaces configuration Displays the configuration for all configured interfaces. UE
show interfaces status Displays the status for all configured interfaces. UE
show interfaces description Displays the description for all configured interfaces. UE
show interfaces counters Displays traffic seen by the physical interface. UE
show ports jumbo-frame Displays the jumbo frames configuration. UE
port storm-control include-
multicast
Enables the device to count Multicast packets. GC
port storm-control broadcast
enable
Enables Broadcast storm control. IC
port storm-control broadcast
rate
Configures the maximum Broadcast rate. IC
show ports storm-control Displays the storm control configuration. PE
show interfaces advertise Displays information about auto negotiation advertisement. PE
Command Group Description Mode
gvrp enable (global) Enables GVRP globally. GC
gvrp enable (interface) Enables GVRP on an interface. IC
garp timer Adjusts the GARP application join, leave, and leaveall GARP timer
values.
IC
gvrp vlan-creation-forbid Enables or disables dynamic VLAN creation. IC