Owner's Manual
326 RIP Commands
www.dell.com | support.dell.com
Default Configuration
RIP auto-send is enabled.
Command Mode
IP Interface Configuration mode
User Guidelines
If auto-send is enabled on an interface, the router only advertises the default route on the
interface, until a RIP message is received. When a RIP message is received, the complete RIP
information is sent.
Example
The following example automatically detects whether RIP information is required to be sent on IP
address 100.1.1.1.
rip version
The
rip version
interface configuration command specifies a Routing Information Protocol (RIP)
version. To return to the default use the
no
form of this command.
Syntax
rip version
{
1
|
2
}
no rip version
• Use RIP Version 1 on the interface.
• Use RIP Version 2 on the interface.
Default Configuration
RIP Version 1 is used on the interface.
Command Mode
IP Interface Configuration mode
User Guidelines
There are no user guidelines for this command.
Console(config)# interface ip 100.1.1.1
Console(config-ip)# rip auto-send