Owner's Manual

Command Groups 41
RMON Commands
SNMP Commands
rip offset Adds an offset to a metric learned via RIP before adding them to the
interface table.
IC
rip default-route offset Generates a default route into RIP. IC
rip authentication Enables authentication for RIP Version 2 packets and specifies the
authentication type.
IC
show ip rip Displays RIP routing information. PE
Command Group Description Mode
show rmon statistics Displays RMON Ethernet Statistics. UE
rmon collection history Enables a Remote Monitoring (RMON) MIB history statistics group
on an interface.
IC
show rmon collection history Displays the requested history group configuration. UE
show rmon history Displays RMON Ethernet Statistics history. UE
rmon alarm Configures alarm conditions. GC
show rmon alarm-table Displays the alarms summary table. UE
show rmon alarm Displays alarm configurations. UE
rmon event Configures a RMON event. GC
show rmon events Displays the RMON event table. UE
show rmon log Displays the RMON logging table. UE
rmon table-size Configures the maximum RMON tables sizes. GC
Command Group Description Mode
snmp-server community Sets up the community access string to permit access to SNMP
protocol.
GC
snmp-server contact Sets up a system contact. GC
snmp-server location Sets up the information on where the device is located. GC
snmp-server enable traps Enables the switch to send SNMP traps or SNMP notifications. GC
snmp-server trap authentication Enables the switch to send SNMP traps when authentication failed. GC
snmp-server host Specifies the recipient of SNMP notifications. GC
snmp-server set Sets SNMP MIB value by the CLI. GC