Owner's Manual

46 Command Groups
www.dell.com | support.dell.com
VLAN Commands
Command Group Description Mode
vlan database Enters the VLAN database configuration mode. GC
vlan Creates a VLAN. VC
interface vlan Enters the interface configuration (VLAN) mode. GC
interface range vlan Enters the interface configuration mode to configure multiple VLANs. GC
name Configures a name to a VLAN. VC
switchport mode Configures the VLAN membership mode of a port. IC
switchport access vlan Configures the VLAN ID when the interface is in access mode. IC
switchport trunk allowed vlan Adds or removes VLANs from a port in general mode. IC
switchport trunk native vlan Defines the port as a member of the specified VLAN, and the VLAN
ID is the "port default VLAN ID (PVID)".
IC
switchport general allowed vlan Adds or removes VLANs from a general port. IC
switchport general pvid Configures the PVID when the interface is in general mode. IC
switchport general ingress-
filtering disable
Disables port ingress filtering. IC
switchport general acceptable-
frame-type tagged-only
Discards untagged frames at ingress. IC
switchport forbidden vlan Forbids adding specific VLANs to a port. IC
switchport protected Overrides the FDB decision and sends all Unicast, Multicast and
Broadcast traffic to an uplink port.
IC
map protocol protocols-group Adds a special protocol to a named group of protocols, which may be
used for protocol-based VLAN assignment.
VC
switchport general map
protocols-group vlan
Sets a protocol-based classification rule. IC
show vlan Displays VLAN information. PE
show vlan internal usage Displays a list of VLANs being used internally by the switch. PE
show vlan protocols-groups Displays protocols-groups information. PE
show interfaces switchport Displays switchport configuration. PE