Owner's Manual

Address Table Commands 87
Address Table Commands
bridge address
The bridge address VLAN interface configuration command adds a static MAC-layer station
source address to the bridge table. To delete the MAC address, use the
no form of the bridge
address
command (using the no form of the command without specifying a MAC address deletes
all static MAC addresses belonging to this VLAN).
Syntax
bridge address mac-address { ethernet interface | port-channel port-channel-number }
[
permanent | delete-on-reset | delete-on-timeout | secure ]
no bridge address [ mac-address ]
•
mac-address —A valid MAC address.
•
interface— A valid Ethernet port.
•
port-channel-number— A valid port-channel number.
•
permanent— The address can only deleted by the no bridge address command.
•
delete-on-reset —The address is deleted after reset.
•
delete-on-timeout— The address is deleted after "age out" time has expired.
•
secure —The address is deleted after the port changes mode to unlock learning ( no port
security
command). This parameter is only available when the port is in learning locked
mode.
Default Configuration
No static addresses are defined. The default mode for an added address is permanent .
Command Mode
Interface configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.