Owner's Manual

Address Table Commands 89
bridge multicast address { mac-multicast-address | ip-multicast-address } [ add | remove ]
{ ethernet interface-list | port-channel port-channel-number-list }
no bridge multicast address { mac-multicast-address | ip-multicast-address }
•
add —Adds ports to the group. If no option is specified, this is the default option.
•
remove —Removes ports from the group.
•
mac-multicast-address —MAC multicast address.
•
ip- multicast-address —IP multicast address.
•
interface-list —Separate nonconsecutive Ethernet ports with a comma and no spaces; a
hyphen is used to designate a range of ports.
•
port-channel-number-list —Separate nonconsecutive port-channels with a comma and no
spaces; a hyphen is used to designate a range of ports.
Default Configuration
No Multicast addresses are defined.
Command Mode
Interface configuration (VLAN) mode
User Guidelines
If the command is executed without add or remove , the command only registers the group in
the bridge database.
Static Multicast addresses can only be defined on static VLANs.
Examples
The following example registers the MAC address:.
The following example registers the MAC address and adds ports statically.
bridge multicast forbidden address
The bridge multicast forbidden address interface configuration command forbids adding a specific
Multicast address to specific ports.
Console (config)# interface vlan 8
Console (config-if)# bridge multicast address 0100.5e02.0203
Console (config)# interface vlan 8
Console (config-if)# bridge multicast address 0100.5e02.0203 add
ethernet g1-9, g2