Specifications

PowerConnect 6024/6024F Release Notes
Release Notes | Page 9
RN-CA-CLIRG-08. CLI command
“router ospf redistribute rip”
The router ospf redistribute rip global configuration command enables
incorporating IP routes that have been learned via the RIP routing process
into the OSPF routing process. To disable the redistribution of RIP routes,
use the no form of this command.
By default, the redistribution of RIP routes is disabled.
If your network contains other routers that do not run OSPF, but do run
RIP routing protocols, the OSPF process can incorporate those routes
learned via RIP. When redistribution is enabled, the router becomes an
“AS Boundary Router” (ASBR).
OSPF is more robust and converges more rapidly than RIP. Re-
distribution of RIP routes should be used with care to avoid network
instability. Redistribution should be done only in one direction. If RIP routes
are redistributed into OSPF, do not redistribute the same OSPF networks
back into RIP.
RN-CA-CLIRG-09. CLI command
“show ip ospf neighbor”
For OSPF routers to become neighbors, they must be directly connected
and agree on:
* IP prefix and subnet mask
* Area ID
* Authentication (none, text, MD5)
* Options (stub, nssa)
* Hello Interval (default 10 sec.)
* Router Dead Interval (default 40 sec.)
The OSPF neighbor state is one of (init, two-way, loading, full). On a
broadcast media, the roles are Designated Router (DR), Backup Designated
Router (BDR), Other (DRother)
RN-CA-CLIRG-10. CLI command
“vrrp preempt”
The router that owns the IP address or addresses associated with the virtual
router always preempts independent of the setting of this command.
RN-CA-CLIRG-11. CLI command
“snmp-server group”
In order to remove SNMP group please use the “no snmp-server group CLI“
command. The index of the group name table is comprised of Group Name,
Security Model, and Security Level. Different views for the same group can be
defined with different security levels. Thus, for example, after having created
the appropriate views, a group can be created for which "no authentication" is
required, while allowing only notification view for "interfaces". A group of the
same name can be created for which "priv" authentication is required. Read-
only views can, for example, be configured for this group for mib2, and
read/write views for interfaces. In this case, the users belonging to this group
(the one who send "priv" packets) can modify all "interfaces" MIBs and view all
mib2.
RN-CA-CLIRG-12. CLI command
“snmp-server host”
The range for username in this command is 0 – 255.
RN-CA-CLIRG-13. CLI command
“snmp-server v3-host”
The range for retries in this command is 0 – 255.
The range for username in this command is 1 – 24 characters.
Note that the type of trap (that is notification or inform) depends on how the
trap receiver has been configured.
RN-CA-CLIRG-14. CLI command
“spanning-tree mst-prioriry”
The range for instance-id is 1 – 15.
RN-CA-CLIRG-15. CLI command
“instance (mst)”
The range for VLAN is 1 – 4093.
RN-CA-CLIRG-16. CLI command
“logging”
The target IP address can be specified either in the standard decimal dotted
notation format or as a fully qualified domain name.