Release Notes

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
System Firmware Version 5.1.1.7 Page 21
VLANs may be administratively assigned to MSTIs in excess of the switch physical limits and without regard to
whether the VLAN is actually configured. Frames are only forwarded on VLANs assigned to interfaces.
Administrators can re-enter SYSLOG server config mode for a particular SYSLOG server entry without requiring the
deletion and re-creation of the entry.
Administrators can configure the web timeout by navigating to: System -> Management Security -> Telnet Server ->
Telnet Session Timeout.
User configured banners (login, exec, MOTD) appear in the running config.
By default, auto-install supports image downgrade for network installs, specific version USB installs (using a .setup
file), and stack firmware synchronization.
A comprehensible message and recommendation is issued when configuring multiple services (telnet, http, etc.) to
listen on the same TCP port.
The terminal length command allows user control over terminal paging.
 Simple Mode
The PowerConnect M8024-k is the only modular switch that defaults to the simple mode of operation. Simple mode
contains a restricted set of commands suitable for control of a port aggregation device that can be deployed in a
network without requiring updates to the network by a network administrator. Users needing switch capabilities which
require the network administrator to modify the network configuration can exit simple mode using the no mode simple
command.
 AAA Authentication
In prior releases, more than one method could be specified for dot1x authentication even though only the first method
was attempted. The CLI and Web now only accept a single method for dot1x authentication.