Release Notes

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
System Firmware Version 5.1.1.7 Page 27
Release 5.0.0.4
Summary
User Impact
Resolution
Affected Platforms
OpenManage UI
does not accept
blank space
character for
port description
Port description does not accept space
Correction the port description
validation to accept spaces.
All 4.2 supported
platforms
"show spanning-
tree detail"
counters are
non-zero for
inactive
interfaces
The user may think that there is traffic over
interfaces that are supposed to be inactive as
far as spanning tree is concerned.
Corrected the counters.
All 4.2 supported
platforms
Unable to
remove 0.0.0.0
as default
gateway on
OOB interface
using the web.
The user may not be able to remove the
default gateway for the OOB interface
causing unwanted traffic to go over the
OOB interface.
Added support for setting the
gateway to 0.0.0.0.
All 4.2 platforms that
support the OOB interface
When
connecting via
SSH, the user is
not prompted to
acknowledge the
MOTD
The user may log in without having
acknowledged the MOTD.
Add functionality to send the
acknowledge question when
new SSH connection is
created, but after
authentication.
All 4.2 supported
platforms
"encapsulation"
command is
unavailable in
interface range
mode
The user could only set VLAN
encapsulation on a single VLAN at a time.
Added support for the
encapsulation command in
interface range VLAN mode.
All 4.2 supported
platforms
M8024-k
OpenManage
Web UI stack
view display
The user could not get accurate information
about a stack of M8024-k switches from the
stack view web page.
Corrected the information
displayed on the stack view
web page.
PCM8024-k
"spanning-tree
transmit hold-
count"
command's
value is not
reflected in
show command
The user could not see the configuration of
the hold-count parameter.
Corrected the output of the
"show spanning-tree detail"
command to include the
configuration of the hold-count
parameter.
All 4.2 supported
platforms
Inconsistent
behavior in
single and range
interface mode
of "spanning-
tree port
The user may be able to configure an
invalid spanning tree port priority in range
mode.
Corrected the error handling so
that the invalid priority is not
used.
All 4.2 supported
platforms
CLI command
"no passwords
strength
exclude-
keyword"
requires
<keyword>
The user could not reset the excluded
keywords to the factory default of no
excluded keywords with a single command.
It was necessary to remove each excluded
keyword one at a time.
Correctly implemented the
"no" form of the "passwords
strength exclude-keyword"
command.
All 4.2 supported
platforms