Release Notes

30 System Firmware Version 5.1.1.7
startup-config
failed error
message is
displayed when
finishing the
Dell Easy Setup
Wizard
startup-config failed error message is
displayed when finishing the Dell Easy
Setup Wizard
Corrected the implementation
of this command so that it
functions correctly.
All 4.2 supported
platforms
In stacking
environment,
"show system
temperature"
command output
is corrupted
CLI output for command "show system
temperature" is corrupted when
pagination is used.
Corrected pagination in the
command handler.
All 4.2 supported
platforms
Error message
for port enable /
disable on IE on
8024F combo
ports
When a copper port was disabled, port was
getting set in no negotiating mode.
Corrected by disabling
negotiation on combo ports
PC8024F
Alignment
issues in the
output of "show
voice vlan
interface"
command
The alignment issues make it difficult for
the customer to read the page.
Corrected alignment issue
All 4.2 supported
platforms
CLI command
"show ip igmp
snooping"
output is
truncated.
The displayed info is not complete on page. Corrected the implementation
of this command so that it
functions correctly.
All 4.2 supported
platforms
vrrp ip
command
accepts invalid
IP addresses
Switch allowed user to misconfigure VRRP
IP
Added checks to return error
when invalid VRRP IP address
is given.
All 4.2 supported
platforms
CLI command
"isdp enable"
does not work
for a range of
ports
User cannot enable isdp on range of
interfaces
Added support to "isdp enable"
command in interface range
mode
All 4.2 supported
platforms
"show interface
Priority-Flow-
Control"
command output
is not formatted
correctly
The user sees the info but it looks messy
and is hard to read.
Corrected formatting issues
PC8024
PC8024F
PCM8024-K
CLI command
"show ip route
192.168.2.2 /24"
not ignoring
host bits.
The user would not always get the correct
list of routes from the "show ip route"
command.
Corrected the logic in the
implementation of the "show
ip routes" command so that the
appropriate list of routes are
shown, depending upon which
optional parameters are given.
All 4.2 supported
platforms
Port channel
goes down
during master
failover.
The members of the stack other than the
master unit and their port channels, i.e. the
Standby units and their port channel
interfaces, are now not affected by a master
failover and the port channel stays up
during failover.
Corrected the logic to check
for active port channels in the
new Standby master unit.
All 4.2 supported
platforms